Why is the UV light on my 700IF+ not working?

If the UV light on your 700IF+ is not working, please remove the bulb from the fitting by following the below instructions:

Important: Disconnect mains electricity supply before handling or attempting maintenance. Always fully read and check the troubleshooting section within your product instruction manual. 

 

  1. Check to make sure the UV light is switched to the ON position.

  2. Push both clips in on either side of the unit to remove the bottom casing.

  3. Unscrew the securing quartz cover/locking screw that is in place.

  4. Twist the cap anti-clockwise until it hits the locking fixture.

  5. Gently twist and pull the quarts of which will expose you too the bulb.

  6. Check that the bulb is intact and has not become loose in the fitting while in transit. Also, check that all of the filaments are in place and have not been damaged within the UV bulb.


If the UV light is still not working, Please contact our customer service team who will be happy to assist with some additional troubleshooting, replacements or repairs.